List of Prompts

The following prompts are displayed.

Enter DGN file format [V7/V8] <V8>: Specify whether the file is DGN V7 or V8

Enter filename for DGN export <default path\filename>: Specify path and filename of DGN file

Specify conversion units [Master/Sub] <Master>: Specify m or s, or press Enter

Specify mapping setup or [?] <Standard>: Specify mapping setup or ? to specify filter of mapping setup

Specify seed file or [?] <default path\filename>: Specify path and filename of seed file

File Format

Specifies the file format of the DGN file being exported.

Filename

The file name can include up to 255 characters and contain letters, digits, spaces, and any special characters not used by Microsoft Windows or this program.

To avoid errors when entering a file name, it is recommended that you specify both the DGN file and path as follows:

path\filename

or

“path\filename”

Specify the path and file name of DGN file.

Units

Specifies a drawing-units value for scaling the DGN file.

Mapping Setups

Specifies the mapping setup of the selected design model.

?

After specifying a filter, a list of available export mapping setups that match the filter is displayed and will re-prompt.

Seed File

Specify a seed file that matches the existing behavior of other commands with filters.

• ?